Properties of the settings-panel remote tab.
Inverse the values recieved during the learn.
Quantization applied when state or value changes.
- no quantization,
only if rack is on
When On, the assigned MIDI learn will work only if the rack of the current object is ON.
Clear the current bind assignation.
Set or get the bind name assignation.
Click on this button and move your MIDI controller to assign it.
Name of the device associated to the MIDI learn.
Use [Ctrl+Click] to delete the name association so the MIDI learn will react with all the connected devices.
MIDI channel used for the MIDI learn.
MIDI Control message number (ie. Control Change, Note, etc) used for MIDI learn.
MIDI message type used for the MIDI learn.
Choose between the 3 MIDI assignation modes in Usine:
mackie control mode
The control react as a in the Mackie control protocol.
Only if you have motorized MIDI controllers connected. Force Usine to send MIDI messages to the connected remote devices and get a MIDI feedback.
soft take over
Soft Take Over if a control is moved on screen and it no longer matches the hardware control, the control will not update until the hardware control matches the onscreen value.
For instance say you have a line fader turned all the way up on the hardware, then you move the onscreen line fader to the bottom. With soft-takeover ON, the onscreen fader will not react to the line fader until you move the line fader all the way down to match the on screen value. The control will then latch on and will be active again.
System exclusive chain used for MIDI learn.
Click on this button and press a key (or a key combination ie. [ALT+E]) on your keyboard to assign it.
Key used for the key learn. Can be a key combination like [ALT+E], etc.
Determines how the Key learn affect the control: absolute or toggle.
Key code value of the key learn.(ex: A=65)
Curve type used for the mapping: log or exp, power curve, linear.
Mapping curve coefficient.
Maximum range of the assignation.
Minimum range of the assignation.
Click on this button and use a control of your OSC device to assign it.
OSC message used for the OSC-learn.
Choose here between 2 modes: real OSC values received or force the values intto the [0..1] range.
OSC tag order
This option is utilized to choose which tag to use when receiving multiple values simultaneously like in an XY values.
time code OFF
Time code learn, used to switch off a switch control.
time code ON
Time code learn, used to trigg an action or to switch on a switch control.
Current private id for this control.
If you experience difficulties in Polyphonic mode, try to recreate new id(s) with this button.
repair ID s
Each Patch shared on the local network uses its own ID (identification number). If you experience issues of Patches that don't send information to the good target, this button will rebuild all these id’s.